How to handle the "wire breakage alarm" displayed on the screen of the spring machine that cannot be eliminated?

Source: This station | Release date: 2022-11-30 16:09:46 | Views: 1057

Summary:

The implementation of the "wire break alarm" for the spring machine is due to the formation of an electrical circuit by the machine, wire frame, signal wire, and wire. If a circuit breaker type conductivity is poor in one of the links, it ma…

The implementation of the "wire break alarm" for the spring machine is due to the formation of an electrical circuit by the machine, wire frame, signal wire, and wire. If a circuit breaker type conductivity is poor in one of the links, it may cause the "wire break alarm" light on the F5 board to turn off, and the system will prompt a wire break alarm.

The solution to the "wire breakage alarm" of the computer spring machine:

1. Firstly, check if the signal wires 5 and 6 from the cable rack to the machine have open circuit and poor contact;

2. Check if there is too much oil contamination in the contact area between the wire and the machine, which affects the conductivity between the wire and the machine;

3. Check the conductivity of the wire: Use a copper wire to connect the wire rack to the machine. If the wire breakage alarm disappears, it indicates that the conductivity of the wire used is not good. At this time, you can turn the wire breakage alarm switch on the wire rack to the other side to turn off the wire breakage alarm function, but the machine will not have a wire breakage alarm after producing the wire.

Previous: How to Control the Shape of Springs in a Camless Spring Machine

Next: The importance of spring machines in the field of precision hardware electronics