CNC spring machine spring damaged

Due to weather conditions, equipment often leaks or trips, making it difficult to maintain a quiet and stable working environment. Trips and leaks occur every few days. The reason is that due to a circuit malfunction in the CNC spring machine, the knife will automatically cut off the circuit.

In this case, the most important thing is to check the servo motor of the spring machine to ensure the safety of some circuits. As long as there is no problem with the servo motor, the circuit failure of the CNC spring machine is not significant. By solving each problem one by one, we can find the problem.

The abnormal manifestation of the spring machine wire frame is to check whether the switch of the wire feeding frame is turned off, when there is no work light display or report on the wire feeding frame. Check if the relay in the circuit board of the cable rack is burnt out. If the working light of the relay remains on, it needs to be replaced. When the spring machine wire feed frame is in an energized state and the frame does not rotate, check whether the wire feed frame motor can operate.

However, it should be noted that CNC spring machines are indeed very convenient for producing springs, but whether it is a brand new spring machine or a second-hand spring machine, spring compression machine, or screw sleeve machine, the maintenance of CNC spring machines is also very important.